1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 221Get this manual
19Remove retainer ring if requiredDiscard retainer ring
f15120To assemble bearings to driveshaft, install new retaining ring (if removed) on the driveshaftApply light coat of
OMC Marine Wheel Bearing Grease to the bearing and driveshaft pressing surfacesPosition the lower bearing on the driveshaft with the lettered side of bearing facing away from the retaining ringPress against inner race of the bearing until it contacts the ring
f16121Lubricate the upper bearingPosition the upper bearing
on the driveshaft with lettered side of bearing facing away from the lower bearingPress against inner race of the bearing until it contacts the lower bearing
r,]l '" 22Using retaining ring pliers, install retaining ring with
i sharp edge facing outMake sure the retaining ring is seated in its groove in the driveshaftWear safety glasses and proceed with care to avoid unsnapping the ring from the pliers