1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 219Get this manual
Bearing Housing Assembly Servicing 1Remove water pump assembly from jet housing rv 2Remove four bearing housing retaining screws, and remove bearing housing assembly from jet housingi safety glasses and proceed with care to avoid
unsnapping the ring from the pliers4Remove O-rings from housing and discard f3l 5Warm bearing housing with propane torch to aid in removal of upper seal carrier'" 3Remove retaining ring with retaining ring pliersWear
Do not apply too much heat as seals or carrier may be damaged
'" 6Allow bearing housing to cool until it is warm to the
r;] 7Place bearing housing assembly in pressPress from the
impeller end of the driveshaft until the seal carrier is free from the housingContinue to press bearings and driveshaft from bearing housing8If seals are damaged, the carrier and seals are serviced as an assemblyApply OMC Triple -Guard grease to seal lips before reinstalling the carrier and seal assemblyr;'] 9To replace the bearing housing seal, remove inner seal