1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 214Get this manual
Installation
Coat the driveshaft splines with OMC Moly LubeDo not coat top surface of the driveshaft as lubricant here may prevent seating of the driveshaft in the crankshaft
r:;J 2Apply OMC Adhesive 'Sealant to the lower exhaust
housing seal inner surfacesPosition two new seals on the housingApply OMC Triple-Guard grease to the seals' outer surfaces and position the housing on the gearcase3Slide the gearcase into place making sure the driveshaft engages the crankshaft, the water tube enters the water pump, and the lower inner exhaust housing does not slip out of position
f31.f614
Apply OMC Gasket Sealing Compound to threads of the gearcase retaining screwsInstall the screws and tighten to the following torques:
inscrews inscrews