1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 205Get this manual
6 DR2061-DR2062
6Install two new seals back to back in the rear of the bearing housing V4use OMC Seal Installer, PIN 326551 V6use OMC Seal Installer, PIN 336311
l!J of the seals before installingInstall the inner seal with lip
rJ 7Apply OMC Gasket Sealing Compound to the metal casings
facing toward the bearing housing, then the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing
f718Lightly apply OMC Triple-Guard grease to new bearing housing a-ringInstall the a-ring in its groove in the housing V4Install new seals on the retaining screwsDriveshaft Bearing Housing Service The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged14156