1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 195Get this manual
3Place the a-ring Q) in groove in the impeller housing4Lightly coat the exterior of the impeller cup with OMC Gasket Sealing CompoundInstall the cup in the impeller housing1]1 5up6Install the impeller housing cover the water tube grommet
with the inside taper
1sl 7Apply OMC Adhesive sealant to flat side of the impeller housing grommet Install the grommet, flat side down
Inl 8Lightly coat the liner with oilWith counterclockwise
rotation, install the impeller into the liner with slot for impeller cam facing out
EI groove, and install the special shaped a-ring seal Installation
Run thin bead of OMC Adhesive sealant in the seal
r:;] 1Apply OMC Gasket Sealing Compound to both sides of a
new impeller plate gasket plate
CDInstall