1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 194Get this manual
Propeller InstallationV4 i pellers; twist and remove all spark plug leads2Place engine's shift lever in NEUTRAL3Coat the propeller shaft splines sparingly with OMC TripeGuard grease'" 1Avoid accidental starting of engine while changing pro-
rv 4Place the thrust bushing shaftpropeller, then slide the in the assembly onto the propeller
IT] 5Install the thrust washer on the propeller shaft splines
rv 6Install the propeller nutpin and tighten to propeller ofnut and torque 120 inIbs(14 Nm)If cotter holes in the
propeller shaft are not aligned, continue to tighten the nut until they are in lineDo not loosen
111 7Insert new cotter pin through the
propeller nut and shaftBend its ends over the nut to secure the assembly
8Make sure engine is in NEUTRAL; give propeller spin It must turn freely
Water Pump ServicingV4, V6