1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 193Get this manual
Propeller InstallationV6 These instructions apply when spacer is brassIf spacer is made of nylon, replace with brass spacer, PIN 320570
ill pellers; twist and remove all spark plug leads2Place engine's shift lever in NEUTRAL
'" 1Avoid accidental starting of engine while changing pro-
f1l 3Apply OMC Triple-Guard grease to propeller shaft and inner taper of large propeller thrust bushing 4Install thrust bushing onto propeller shaft with shoulder of thrust bushing facing aft5Install propeller on propeller shaft by aligning splines and pushing until it seats on the thrust bushing
[!] 6Install the spacerengaging the propeller shaft splines7Wedge block of wood between propeller blade and the anti-ventilation platef1l f1l 8Install the propeller nut 70-80 ftIbs(95-105 Nm)