1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 170Get this manual
- Disassembly
'8l 1To separate the adapter and the inner exhaust housing assembly from the outer exhaust housing, remove the front two rubber thrust mount screws and five retaining screws
19l2Remove the remaining thrust mount screwLift the mount
plate and pry the mount
from the adapter
f'1Ol3The inner exhaust housing
and the water tube are attached to the adapter with five screwsIf necessary to disassemble, remove the five screws and lift the inner exhaust housing from the adapterDiscard the gasket4The water tube and water tube grommet can be removed from the base of the inner exhaust housing
Assembly
r:j"1l1up
Place the upper thrust mount into the adapterPosition radius side of the mount facing aft and "TOP" mark facing