1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 150Get this manual
31Rotate cylinder block so that crankcase mating flange is facing up 123132Remove all spark plugs and push all pistons to top dead
centerRemove numbered connecting rod caps and hold rods to the outside with rubber bands
1241 33Gently lower crankshaft assembly into place:
Orient all crankcase seal ring gaps facing up Tap crankshaft upward with rawhide mallet to seat crankshaft and lower crankcase head
Locate each center main bearing split sleeve on its dowel pin Loosely secure upper and lower crankcase heads with two screws
125134Lubricate the crank pins and bearing assemblies with
Evinrude or Johnson Outboard LubricantSlowly pull the connecting rods up to crankshaft and install bearings
126135Lubricate threaded portion of the rod cap screws with