1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 140Get this manual
f171 10Remove the main bearing screws and the crankcase flange screwsr;Bl 11Turn the powerhead with the intake facing up, and then tap lightly upward on the crankshaft until the crankcase halves begin to separatef191 12Remove crankcase to expose the crankshaft and connecting rods for further disassemblyPistons, connecting rods, rod bearings, and bearing retainers are wearing parts and seat with operation of the engineBecause of this, it is essential to maintain their original positions at reassemblyUsing an indelible ink marker, mark each connecting rod, cap, and bearing component when they are removed to ensure correct mating upon reassemblyKeep the needles of each cylinder togetherLoosely install cylinder heads to prevent pistons from falling out 1201