1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 259Get this manual
COA3238
4927Slide the retainer plate down the propeller shaft and into the gearcase with tab facing down
i the retaining ring Into groove In gearcase with sharp
install
outside edge facing aftThe retaining ring is under extreme pressure during installationWear safety glasses and proceed with care to avoid unsnapping the ring from the pliersLook inside the gearcase and make sure that the ring is seated in groove29Thread one OMC Guide Pin, PI 383175 retainer plate
into the
5230Stick the reverse gear thrust washer to the back side of the propeller shaft bearing housing with OMC Needle Bearing Assembly Grease
rs:;, 31Lightly apply OMC Gasket Sealing Compound to the aft