1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 255Get this manual
Assembly
Make no dry assembliesLubricate bearings, shafts, and gears with OMC Ultra-HPF gearcase lube
12411Oil and install new bearing in aft end of the bearing
housing using OMC Bearing Installer, PI 335820Press against the lettered side of the bearing to prevent damage to the bearing when installingPress the bearing into the housing until the tool is seated on the housingbearing housing using OMC Bearing Installer, PIN 321428Press against the lettered side of the bearing until the tool is seated on the bearing housing
12512Oil and install new bearing in the forward end of the 126273Install new seals back to back in aftPIend335821.bearing ofthe Apply housing using OMC Seal Installer, N
OMC Gasket Sealing Compound to the metal casing of the seals before installing Install the inner seal with lip facing into the bearing housing and install the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing4lightly apply OMC Triple-Guard grease to new bearing housing O-ringPlace the O-ring in groove ofthe bearing housing