1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 253Get this manual
r;Bl 15Use OMC Bearing Puller PIN 432130 attached to OMC Slide Hammer PIN 432128 to remove the forward bearing cupSecure the puller jaws into grooves behind the cup with jaws facing port and starboardUse OMC Wrench PIN 334359 to hold the puller while tightening the jaws
f19l 16Use OMC Puller Bridge PI 432127 and OMC Small Puller PI 432131 to remove the driveshaft seals from the
gearcaseInspect bearings in placeIf bearing is removed for any reason, it must be replaced'
1201 17Remove the upper driveshaftbearing and bearing
sleeve from the gearcase using the same two toolsDiscard the bearing
18To remove the pinion bearings, assemble the following components from OMC Universal Pinion Bearing Remover and Installer PI 391257:
PI 326582 Rod
PI 326583 Pilot Plate PI 326577 Remover and Installer