1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 244Get this manual
Assembly
Make no dry assembliesLubricate bearings, shafts, and gear with OMC Ultra-HPF gearcase lube
rv bearingthe small using OMC Bearing in the propeller shaft 1Oil bearing and install housing Installer, PIN 339751Press against the lettered side of the bearing when installingf21 2Oil the large bearing and install in the propeller shaft bearing housing using OMC Bearing Installer, PIN 339751Press against the lettered side of the bearing when installingf31 3Install two new seals back to back using OMCSeallnstaller, PIN 335822Install inner seal onto the tool with lip facing away from the toolInstall the outer seal onto the tool with lip facing the toolApply OMC Gasket Sealing Compound to the metal casing of the sealsInstall the seals into the housing until the tool is seatedApply OMC Triple-Guard grease to the seal lips after installing4Apply OMC Triple-Guard grease to new bearing housing a-ringPlace the a-ring in the bearing housing groove32551