1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 215Get this manual
Installation 1Insert the stop button leads and the throttle cable through the lower engine cover grommet2Apply OMC Triple-Guard grease to the two steering handle bushingsPlace the bushings into the steering bracketAttach the steering handle to the steering bracket1sl3the the steering handle can be pivoted and maintain any position 4Slide the protective sleeve over the stop button leadsf515Secure stop button ground lead to bottom ignition coil mounting screwTighten screw to torque of 48-96 inIbs(5,4-10,8 Nm)rJl6Using OMC Insert Tool, PIN 322697, install the stop button lead into the plugConnect the 1-pin Amphenol connectorSecure connector with wire retainer1017Thread the connector onto the cable housing 1314 in (44 mm) from end of the cable sleeveSecure connector in place with nut8Thread the bracket onto the cable until seatedr:;J 9Position the connector on the throttle armSecure the connector to the throttle arm using two washers and cotter pinf1l10Secure the bracket to the lower engine cover using shoul der screw and spacer11To adjust the throttle cable, refer to Synchronization and linkage Adjustment, Section 1 24193