1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 51Get this manual
Remote Control Cable Installation Engine, 9.9 thru 30 i cables are disconnected at battery"" To prevent accidental starting of engine, verify that battery
Control Cable Identification9.9 thru 30
111 1Put the control handle into NEUTRAL positionThe throttle
cable casing guide will retract completely and the shift cable casing guide will go to the midpoint of its travelcable casing guide must retract and the throttle cable casing guide must begin to extend3As you move the control handle into REVERSE, both casing guides must extend
111 2As you move the control handle into FORWARD, the shift
4Identifyeach control cable for proper installation later
i before continuing with installationThrottle Cable9.915
"" Control cable identification and function must be correct
1Remove the rubber grommet from front of lower engine coverRemove cable retainerApply liberal amount of OMC TripleGuard grease to both anchor block pockets