1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 325Get this manual
11Oil and install the manual release valve Thread the valve all the way into the manifoldTighten the valve to torque of 45-55 inIbs(5-6 Nm)Using OMC Retaining Ring Pliers, PI 303857, install the retaining ring ith the sharp edge of the ring facing outG2l 12Oil and install the trim-up relief valve seat Place the core and spring in the seat f11l '"
and O-ring
11Jl 13PJace the steel ball in the manifoldOil and install new filter valve seat and O-ring in the position shown14 14Insert the filter up through the manifold plate Using the three screws, flat washers, and lock washers, secure the manifold plate to the manifoldTighten the three screws evenly so that the plate does not become cockedTighten the screws to torque of 25-30 inIbs(2,8-3,4 Nm)15Clean the oil reservoirInstall new O-ring on the reservoirf.i51 16Position the oil reservoir on the manifoldInstall the three retaining screws with lock washersTighten the three screws securelyyour thumb, press the valve seat CD and O-ring into the manifoldThen, press the valve core Q) and O-rings into the seatInsert the spring into the valve corerr7l 18Insert the trim-down pump relief valve and spring the manifold in the position shown rr7l 19and install new high pressure port O-ring position shown