1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 323Get this manual
r:;::;] 52Remove and discard the seals from the trim pistonsCarefully clean the trim pistons and rods and install new seals
174 53Using OMC Trim Sleeve Remover, PIN 325065, pry the
trim sleeves from the manifoldWhen removingrock the sleeve back and forth with your fingers while prying with the toolscoringReplace the sleeves if scuffed or grooved
175 54Inspect the cylinder bore of each of the sleeves for r:;;l 55Remove the seals from both trim sleevesClean the
sleevesOil and install new seals on the sleeves, as shown
COl.2488