1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 316Get this manual
COA2433
20 cUsing sharp screwdriver, pry the scraper out of the end
capDiscard the scraperscraper and O-ring have been removed from the end cap, the outside O-ring can be removedClean the cap thoroughlyDiscard the O-ri ngsr:;:;l eOil and install new O-ring and scraper CD in the end capThe scraper is installed with the lip facing out and can easily be pressed in with your fingers or with large flat tool in the palm of your hand
21 dPry the O-ring out ofthe end cap using flat toolOnce the
23 fOil and install new O-ring Q) on the outside ofthe end capUsing wire brush, clean all Locktite material from the threads on the tilt rodUsing OMC Tilt Cylinder Seal Protector, PIN 326005, slide the end cap onto the rod
25 hClean the threads on the rod with