1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 286Get this manual
Power TrimTilt Servicing Removal
'1l1Separate the power trimtilt connector, and remove the rubber grommetrJl2Remove the terminals from the connector using either flat-blade screwdriver to depress the tab in back of the connector or suitable tool to depress the tab in front of connector3Remove clamp and disconnect 2-pin Amphenol connector4Disconnect two bullet connectors for the tilt limit switch1sl5P.u ll wires through the hole in the port side of the lower engine coverrJl6Unscrew the manual release valve, raise the unit, and lock it in place with the tilt support