1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 229Get this manual
123117Apply OMC Triple-Guard Grease or Lubriplate 777 to the handle end of the starter ropeUsing OMC Special Tool
PIN 378774 (Starter Rope Threading Tool), thread the starter rope
through the handlePress the starter rope into the channel of the rope anchor, with end of starter rope butting firmly against end of channelPress the anchor into the handle18Check operation of the starter pawl when the starter rope is pulled outThe starter pawl should extend when the starter rope is pulled and retract when the starter rope recoils[:;;119Install the starter lockout assembly lockout lever spring, and thick washer to the starter housingPlace the thin washer under head of the screwTighten the screw securelyInstallation
r:;;l r:;;;] 1Position the starter assembly onto the motorPlace the lifting ring on the rear screw mounting bossInstall the five starter housing retaining screwsBe sure to place washers between the starter housing rubber mounts and the motorTighten the three starter housing screws to torque of 10-12 ftIbs(14-16 Nm)Tighten the two starter handle bracket screws to torque of 60-84 inIbs(7-9 Nm)