1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 215Get this manual
Assembly Before beginning assembly procedures, all gearcase components must be thoroughly cleaned and in serviceable conditionRefer to Cleaning and Inspection, Page 6-4After the gearcase has been thoroughly cleaned and inspected, install new pinion bearing in the gearcase as follows:
14311Assemble the following components of OMCPinion Bearing Remover and Installer PIN 391257 as shown
-20 12 inHex Head Screw PI 326584 Spacer inD.DFlat Washer PIN 326582 Rod PIN 326575 Installer -20 inHex Head Screw PIN 391260 Plate
2Place the bearing on the installer tool with the lettered side of the bearing facing the toolUse OMC Needle Bearing Assembly Grease to hold the bearing on the tool3Insert the tool with the bearing into the gearcaseDrive the bearing into the gearcase until the washer on the tool contacts the spacer
COA3082
14414Remove the toolPosition new D-ring CD on the pinion