1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 212Get this manual
32 DR2061
1301 f31l6Oil, then install new bearings in the bearing housing using OMC Bearing Installer, PIN 326562 Press
against the lettered side of the bearing to prevent damage to the bearings when installing
132337Use OMCSeallnstalier PIN 326551 to install two new
seals back to back in the rear of the bearing housingApply OMC Gasket Sealing Compound to the meta casi ngs of the seals before installingInstall the inner seal with lip facing toward the bearing housing, then the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installinghousing O-ringInstall the O-ring in its groove in the housingInstall new O-rings on the retaining screwsDriveshaft Bearing Housing Service The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged