1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 175Get this manual
General Safety Warnings
Before working on any part of the midsection, read the section called Safety at the end of this manualTo avoid accidental starting of engine while servicing, take adequate precautions to disarm the ignition system: Connect the engine's wiring harness to the boat's wiring harness with the key switch in OFF position Twist and remove all spark plug leads from the spark plugs Disconnect the battery cables from the batteryTo prevent explosion or fire under the engine cover after servicing: Check entire fuel system for leaks Make sure all electrical and ignition leads are routed and clamped in their original positions, away from rotating engine parts Make sure all electrical fittings are tightReplace any locking fastener (locknut or patch screw) if its locking feature becomes weakDefinite resistance to tightening must be felt when reusing locking fastenerIf replacement is indicated, use only authorized replacement or equivalentTest the unit's shift system, including the start-in-gear prevention feature, before returning the engine to the customer