1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 157Get this manual
11 COB1250
11If removed, install new lower main bearingWhen pressing on the bearing, support the crankshaft between the two lower counterweights, and press against the lettered side of the bearingr,Q112Install the main bearing retaining ring with its square, sharp edge facing away from the bearingf11l13Oil and install the two main bearing assembliesThe split sleeve retaining rings should face away from the flywheel taperr:;J 14Apply OMC Gasket Sealing Compound to new upper crankshaft seal's outside diameterUse OMC Seal Installer, PIN 326567, to install the sealSeal lip must face bearing
15Lightly coat new upper main bearing a-ring with OMC Triple-Guard grease16Install main bearing assembly and a-ringSeal must face up