1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 155Get this manual
Assembly
Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
INotel Use new gaskets, seals, and O-rings during assemblyrl1Apply OMC Needle Bearing Grease to the 28 wrist pin LJ bearingsInstall the bearings in the wrist pin boreAlign the bearing in the bore using OMC Wrist Pin Bearing Tool, PIN 336660
r2J rJl2Place the two wrist pin thrust washers on the tool with
flat side of the washers facing out