1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 126Get this manual
3 DR4737
STEPSTOP CIRCUIT TEST
Elimination Test&
1Disconnect 5-pin Amphenol connector between stator assembly and power pack
rJl2Eliminate stop circuit by inserting jumper wires in the "A", "8", "C", and "0" terminals of both connectorsTo avoid possible shock hazard, do not handle coils or spark tester during cranking tests
3Crank engine and observe results at spark tester If spark now jumps alternately at each gap, the problem is in the stop circuitGo to Ohmmeter TestStop Button or Ohmmeter TestKey Switch If some spark is present, go to STEPSENSOR COIL TEST If no spark is present, go to STEPCHARGE COIL TEST4Complete all circuits disconnected during this test