1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 123Get this manual
7 DA4712
7Disconnect the 5-pin Amphenol connector between the stator and power packAttach jumper lead to power coil terminals "C" and "0" in the stator end of the connectorrJl 8Calibrate ohmmeter on appropriate scaleAlternately, attach meter leads between terminals "C""0", and clean engine ground Meter must show high reading9Attach meter leads to power coil terminals "C" and "0" If meter shows 400 40 ohms, replace power pack If your test results vary, replace statorINotel Do not run the engine with its power coil leads disconnected!
QuikStart Always ON