1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 122Get this manual
5 DR4041 DR4287
7The engine must be stopped before testing each remaining cylinder8Repeat Steps thru for each of the remaining cylinders using the temporary TDC marksTest results must be the same for all cylinders If some sensor coils do not react properly, replace the timer base If no sensor coil reacts properly, refer to Loss of QuikStartLoss of QuikStart 1Disconnect whiteblack lead between the power pack and temperature switchf51 2Calibrate ohmmeter on appropriate scaleConnect between temperature switch whiteblack lead and clean engine ground If meter shows high reading when engine temperature is less than 890 (32 C), go to Step If meter shows low reading, test the temperature switchRefer to Temperature Switch Test, Section 43Install junction box at the timer base 5-pin Amphenol connectors