1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 83Get this manual
Inspection
1s1 1To test the solenoid windings, calibrate an ohmmeter on low scale and connect between the purplewhite and black leads Meter should indicate 5.5 1.5 ohms2To test solenoid valve and seat: Lightly pressurize inlet fitting with alcohol and syringe With lever in run position, no fluid should enter inlet fitting With lever in prime position, fluid should come out both outlet fittingsf7l 3To inspect or replace internal components, remove the four solenoid cover screws1s1 4When assembling solenoid, back up screws in their holes to engage original threads and tighten securelyInstallation