1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 70Get this manual
Component Servicing Any time that the VRO oil supply line has been disconnected from the engine, you must run 50:1 fuelloil mixture in the fuel tank for period of time sufficient to verify oil consumptionOnce oil consumption has been verifiedyou can switch back to clear fuel in the tankOil Supply Hose and Pickup Assembly If you suspect that the oil supply to the restricted, check two areaspump is being
1Remove the pickup assembly and inspect for clogged or contaminated filter Remove the four No25 Torx screws and remove the pickup assembly from the reservoir Carefully remove the pickup filter and push with mild solvent to remove any contamination Install the filter, being careful not to move the pickup assembly on its support rods2With the pickup assembly out of the reservoir, vacuum test the system to check for air leaks Carefully remove the oil hose from pickup assembly and from engine oil inlet fitting Use low pressure air to purge hose of oil Use cap holder PIN 329661 hose