1994 Johnson/Evinrude "ER" 60 thru 70 outboards Service Manual, Page 40Get this manual
Synchronization and Linkage Adjustments 60, 6SWM, 70 Remote Control It is important that this step-by-step procedure be followed in sequence and be performed exactly as written to ensure consistent engine idling and smooth operation throughout the RPM rangeThe flywheel has two timing gridsFor remote control models, use the second timing grid (flywheel rotating in clockwise direction)Remove the throttle cable from the throttle control arm and the anchor pocket beginning this procedureSet Timing Pointer If the timing pointer or intake manifold has been disturbed, check the top dead center timing pointer alignment
i ing, twist and remove all spark plug leads
1To prevent accidental starting of the engine while servic-
[":;1 2Center the timer pointer Rotate the flywheel in LJ clockwise direction until the cast-in mark is approximately 1112 in(4 cm) past the timing pointer
1'::;']3Install OMC Piston Stop, PIN 384887, in No.1 spark plug hole and turn in center portion until it contacts the No.1