1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 223Get this manual
Installation
r:;l 1Apply OMC Adhesive sealant to lower exhaust housing seal inner surfacesPosition two new seals on housingApply OMC Triple-Guard grease to seal outer surfaces and position housing on jet drive housing
2Slide jet housing into place, making sure driveshaft engages crankshaft, water tube enters water pump, and lower inner exhaust housing does not slip out of positionr:;J r:;l 3Apply OMC Gasket Sealing Compound to threads of jet housing retaining screws and rear exhaust housing screwInstall two 38 -16 V2 inscrews in forward holes and two 38 -16 inscrews in rear holes Install rear spacer and screwTorque all screws to 18-20 ftIbs(24-27 Nm)
4Install key, bushing, shims, tab-washer, and nut on driveshaftBe sure shims are placed in original positionRefer to Impeller Clearance Adjustment141 5When proper clearance adjustment is achieved, torque