1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 219Get this manual
19Remove retainer ring
if required
Discard retainer ring
r:J5l 20To assemble bearings to driveshaft, install new retaining ring (if removed) on the driveshaftApply light coat of
OMC Marine Wheel Bearing Grease to the bearing and driveshaft pressing surfacesPosition the lower bearing on the driveshaft with the lettered side of bearing facing away from the retaining ringPress against inner race of the bearing until it contacts the ringf16l 21Lubricate the upper bearingPosition the upper bearing on the driveshaft with lettered side of bearing facing away from the lower bearingPress against inner race of the bearing until it contacts the lower bearing
i sharp edge facing outMake sure the retaining ring is
22Using retaining ring pliers, install retaining ring with
seated in its groove in the driveshaftWear safety glasses and proceed with care to avoid unsnapping the ring from the pliersr:J8l 23Install thrust washer against upper bearing with dished center section facing upwardPlace upper seal carrier assembly onto the driveshaftApply OMC Triple -Guard grease to two new O-rings and install on upper seal carrierf191 24bearing housing cavity with OMC Marine Wheel Beanng Grease