1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 201Get this manual
29 31956
11If removed, install new forward gear bearingApply OMC Needle Bearing Assembly Grease to 25 new rollersInstall the rollers in the bearing 12911301 12Using OMC Bearing Installer, PIN 339778, install the bearing, lettered side facing tool127[ 13Install the thrust bearing on the forward gear126 114Place bearing housing on the forward gear
f31l 15Install 0.030 inof shims and the thrust bearing in the flange, and install on the forward gear32[ 16Install set screws and torque to 144-168 inIbs(16-19 Nm)Use no thread sealant133[ 17Anchor dial indicator gauge to flat, level surface133 118Position the gear assembly so the indicator needle makes contact with the flange on the housingThe indicator needle must be parallel with the side of the gear housing and perpendicular to the table surfaceZero the dial indicatorr::;l 19Grip the bearing housing 1800 apart and pull up to get reading on the indicatorTo determine thickness of shims; use the following example: 0.030 inof shims in the assembly0.020 inyour reading on the dial indicator