1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 190Get this manual
r,Q1 14Slide the propeller shaft onto the shifter shaft, align the
hole in the shaft with the hole in the clutch dog, install the pin and then, new clutch dog retaining springPosition three coils over each end of the pin, making sure none of the coils overlap or are looser:J1l 15Locate the propeller shaft assembly and align the forward bearing housing with the detent lever toward the topPush the detent lever down, into REVERSE positionBe sure the thrust bearing and the thrust washer are properly positioned Insert the propeller shaft assembly into the gearcase, being sure to align the shift housing pin with hole in forward end of gearcase housingr:;:;J 16Lubricate two new shift rod cover a-rings
COA3568
with OMC Triple-Guard greaseInstall the a-rings into the shift rod coverf131 17Place the shift rod grommet and shift rod spacer (EX models) on the shift rodGrease the threaded end of the shift rod and insert it through the coverTurn the shift rod while pushing it through the cover to avoid damaging the a-rings