1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 189Get this manual
4519 4520 4521
fil 7Lightly coat the detent ball and spring with OMC Needle Bearing Assembly GreaseFirst, insert the spring in the housing, then the ball
i lever toward either side of the housingDepress the ball
8Wear safety glasses to avoid injuryFace the detent
and spring with punch while pushing the detent lever into the housing Once the detent lever is past the ball, rotate the lever toward the rear of the housing, then move the detent lever to engage NEUTRAL position1sl 9Thoroughly grease the original 25 needles with OMC Needle Bearing Assembly Grease and place in the bearing case
161 10Face the narrow arms of the shifter Q) toward the housing,
then reach inside and attach it to the detent leverAlign the pivot holes and insert the retaining pin
L!J Rest the cradle on the shift shaft V, then attach the cradle
and shaft to the wide arms ofthe sh ifterPu II the detent lever back up to NEUTRAL position to hold the cradle and shaft in placef81 12Coat thrust bearing and thrust washer with OMC Needle Bearing Assembly GreasePlace the bearing on the back of the forward gearSet the washer on top of the thrust bearingInsert the gear, bearing, and washer assembly into the bearing housingBe careful not to dislodge any of the loose bearingsf81 Bearing and washer must be installed exactly as