1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 148Get this manual
Installation
rv housing flangeNo2 gasket sealant to inner exhaust 1Apply Permatex lJ
'2l2Install new base gasket on adapterCoat both sides with
OMC Gasket Sealing CompoundTo ensure proper sealing, mating surfaces must be clean and free of oil, grease and foreign matter
3Coat the driveshaft splines with OMC Moly LubeDo not apply lubricant to end of driveshaft
Using hoist, slowly lower powerhead onto exhaust hous"" 5Install two steering arm to upper mount screws and
lll torque to 65-70 ftIbs(88-95 Nm)
6Apply OMC Gasket Sealing Compound to the threaded portion of the powerhead to exhaust housing screwsLoosely install all fasteners7Torque the six large screws retaining the powerhead to the exhaust housing to 18-20 ftIbs(24-27 Nm)8Torque the five small screws retaining the powerhead to exhaust housing to 60-84 inIbs(7-9 Nm)In order to achieve proper sealing and prevent gasket damage, the powerhead mounting screws must be retorqued after engine has reached operating temperature and has been allowed to cool