1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 145Get this manual
The port head has temperature switch with two wires, the starboard head has switch with one wire23Rotate cylinder block so that starboard cylinder head surface is facing up and horizontal to the floor24 Repeat Steps 18 through 19 for starboard cylinders25Rotate cylinder block so that crankcase mating flange is facing up26Push all pistons to Top Dead CenterRemove numbered connecting rod caps27Gently lower crankshaft assembly into place Orient all crankcase seal ring gaps facing up Locate tab on lower bearing seal housing in recess in crankcase Locate each center main bearing split sleeve on its dowel pin1191 28Lubricate No.1 crankpin and bearing assemblies with Evinrude or Johnson Outboard LubricantSlowly pull No.1 connecting rod up to crankshaft and install bearings1201 29Lubricate threaded portion of No.1 rod cap screws with Evinrude or Johnson Outboard LubricantAlign dot on rod cap with dot on the connecting rodInstall rod cap screws finger tight IN tel Be sure alignment dot on rod cap matches dot on rod and