1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 144Get this manual
14 35264
r:;:;] 14Using OMC Cone PIN 331913 and Driver PIN 396747, install new wrist pin retaining rings in each wrist pin holeGap of retaining ring faces up, away from notch in piston
15Repeat Steps 11 thru 14 for each piston
r:;:;J 16When all pistons and connecting rods are assembled, install piston ring setsInstall each piston ring set on the piston that was used to test the ring clearances
INotel Be sure gap of ring fits squarely around dowel pin.Before continuing, be certain all OMC Gel-Seal II sealant has been removed from the cylinder block and crankcase mating flangesIf traces of hardened OMC Gel-Seal II sealant are left, main bearing misalignment might occurRefer to Cleaning, this section
17Rotate cylinder block so that port cylinder head surface is facing up and horizontal to the floorr:J5l 18Coat pistons, rings, cylinder walls, and OMC Ring Compressor PIN 336314 (PIN 336313 for oversize pistons) with Evinrude or Johnson Outboard Lubricant19Center connecting rod in piston and locate piston rings on dowel pinsSlide No.2 piston assembly into top cylinder while guiding connecting rod through cylinder block20Repeat Steps 18 and 19 for remaining pistons on port sider:J6l 21Lightly lubricate new cylinder head O-rings with OMC Triple-Guard greaseInstall O-rings in cylinder block11]1 22Apply V16" (2 mm) bead of RTV adhesive around each water passage on the cylinderDo not apply adhesive around thermostat seat area Install port cylinder head and install retaining screwsFollowing torquing sequence on cylinder head, torque all screws in stages to 20-22 ftIbs(24-27 Nm)