1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 142Get this manual
19l 13Inspect center main bearing and split sleeves for excess wear, nicks or scratchesReplace if necessaryf1Ol 14Inspect crankshaft rod bearings for excess wear, nicks or scratchesReplace if necessaryAssembly Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson and Evinrude Outboard LubricantUse new wrist pin retaining rings, gaskets, seals, and -rings during assemblyr:jl 1Oil the end of the crankshaftUse OMC CrankshaftBearing Sleeve Installer, PIN 338647, and place new lower main bearing onto crankshaft with lettered side facing the toolInstall bearing until it seats in the crankshaft
I.J Crankshaft BearinglSleeve Installer, PIN 338647, and drive the
121 Oil the end of the crankshaftPlace new sleeve in OMC If the installer sticks on the sleeve after installation, thread OMC Slide Hammer, PI 391008, into installer and pull offInspect sleeve surface after installingSleeve must not be used if surface is damaged