1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 121Get this manual
STEPCHARGE COIL TEST Ground Test
1Disconnect 6-pin Packard connector between stator and power pack2Attach 6-pin Packard test adapter from OMC Ignition Test Kit, PI 434017, to stator connector3Set peak-reading voltmeter to "POS" and "500"
rv 4Connect the meter black lead to aleadsCrank engine and Alternately connect meter red lead clean engine groundbetween brown, brownyellow stator observe meter at each connection:
Any reading indicates charge coil is grounded Locate and repair ground, or replace stator assembly5Repeat Step using brownblack and brownwhite stator leads6If no reading is indicated in Steps or 5, go to Output TestOutput Test 1Set peak-reading voltmeter to "POS" and" 500"2Attach meter black lead to brown stator leadAttach meter red lead to the brownyellow stator lead3Crank engine and observe meter4Repeat Steps and with meter black lead attached to brownblack stator lead and meter red lead attached to brownwh ite stator lead: If meter shows 150 volts or higher, go to next step indicated in Troubleshooting Sequence Chart, Page 3-24 If meter shows less than 150 volts, check condition of wiring and connectors If wiring and connector condition is good, go to Ohmmeter TestOhmmeter Test INotel All ohmmeter tests must be performed with engine NOT running1Calibrate ohmmeter on appropriate scale