1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 114Get this manual
Output Tests
ill plugs installed and torqued in the cylinder headIf necesSTEPTOTAL OUTPUT TEST
ill spark tester during cranking tests
All cranking output tests must be performed with spark
sary to remove the spark plugs, be sure to keep the spark tester away from open spark plug holes
"'" To avoid electrical shock, do not handle ignition coils or
1Twist and remove all spark plug leadsf1l 2Adjust the gap on the spark tester to 716 in(11 mm)Connect tester leads to the spark plug leadsSecure tester clip to clean engine groundNote To prevent high voltage arc, route tester leads at least in(51 mm) from any metal surface3If equipped, install the clip onto the emergency stop switchCrank the engineSpark should jump each tester gap alternately4Refer to Troubleshooting Sequence Chart, Page 3-24Start with your specific fault symptom and continue troubleshooting in sequenceit is possible for the ignition system to have problem but still produce good outputIf the engine "pops" or "backfires" during starting, the ignition may be out of timeCheck the following: Coil primary wire routing Spark plug lead routing Timing wheel, timing wheel key, and timing sensor assembly Synchronization and linkage adjustments