1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 98Get this manual
1141 5Wrap single layer of cellophane tape around the crankshaftBottom of tape should be just below the crankcase flatsThe tape will protect the flywheel cover seal from damage during flywheel cover instanation6Be sure the wave washer is positioned on the starter pinion shaftthe crankshaft after the cover is seated rw
f161 7Carefully install the flywheel coverRemove the tape from
8Install the 17 flywheel cover screws and tighten to 40-50 inIbs(4,5-5,7 Nm) 9Install the spark lever assembly on the throttle camshaftSecure the spark lever assembly with the retainer
10Position the timing wheel on the crankshaftInstall the timing pointer and adjust it as described in Synchronization and Linkage Adjustment, Section 1f171 11Remove old adhesive from the threads of the timing wheel screwPrime with OMC Locquic Primer and let dryApply OMC HT 400 to threadsInstall the screw and tighten to 120-140 inIbs(14-16 Nm)Sources of intense light can disrupt the optical ignition sensor, causing misfireAvoid running the engine in bright sunlight while the timing wheel cover is removedDo not point timing light directly at the sensorAnytime the flywheel cover has been removed, verify the timing pointer location and linkage adjustments