1994 Johnson Evinrude "ER" 60 LV 150, 150C, 175 Service Manual, P/N 500611, Page 41Get this manual
Remote Control Cable InstallationEngine ill cables are disconnected at batteryControl Cable Identification "" To prevent accidental starting of engine, verify that battery
rv cable the control handlewill retract completely and the shift 1Put into NEUTRAL position The throttle casing guide
cable casing guide will go to the midpoint of its travel
rv cable you move the musthandle into FORWARD, thecable 2As control shift casing guide retract and the throttle
casing guide must begin to extend3As you move the control handle into REVERSE, both casing guides must extend4Identify each control cable for proper installationThrottle Cable
1Remove the anchor block cover from starboard lower engine coverRemove cable retainerApply liberal amount of OMC Triple-Guard grease
2Extend throttle cable and lubricate with OMC Triple-Guard grease
3Verify that the remote control fast idle lever is down in the RUN position4While rotating the propeller shaft, move the remote control handle from NEUTRAL to the FORWARD detent and then halfway back to NEUTRALThis positions the control for proper throttle cable adjustmentFailure to follow this procedure exactly might cause accelerated wear of shift system components and high shifting effort