1994 Johnson/Evinrude "ER" 2 thru 8 outboards Service Manual, Page 242Get this manual
Manual Starter Servicingthru 8 Removal
i twist and remove spark plug leads
"" 1To avoid accidental starting of engine while servicing,
rv starter off powerheadhousing retaining screws and lift 2Remove the three starter
3Push on side of locking tab and pull on lockout cable to disconnect cableRemove the plunger and spring from the cableStarter Rope Replacement
'3l f414Pull starter rope out to end of ropeTurn pulley until rope
anchor in pulley and rope guide in housing alignInsert tool through pulley and starter housing to hold pulley against spring tensionend of rope and remove handlePull old rope out through pulley1515Pry anchor out of handle and remove anchorUntie knot in
6Cut new rope 59V2 in(151 cm) longFuse both ends of rope1cl7Check spring pre-wind by removing tool from pulley and turning pulley counterclockwise until tightTo avoid injury or damage do not release pulley when spring is woundLet spring slowly unwind 114 1114 revolutions until rope anchor in pulley and rope guide in starter housing are alignedReinsert tool to hold pulley