1994 Johnson/Evinrude "ER" 2 thru 8 outboards Service Manual, Page 237Get this manual
Assembly
1Lubricate spring cavity and spring, pulley, and spindle, with OMC Triple-Guard grease or Lubriplate 777f1012Insert spring through housing and position spring and pulley so spring hook engages slot on pulley as shownsiveSpray threads with OMC Locquic Primer, let dry, and apply OMC Nut LockPosition and hold spindle slot over starter housing ribTighten screw to torque of 60-84 inIbs(7-9 Nm)
G113Clean threads of spindle retaining screw to remove adhe-
"" f12l4Wind pulley counterclockwise until outside loop of spring is pulled into starter housing pocket CD To avoid injury or damage do not release pulley when spring is woundContinue winding pulley until spring is tight5Install ropeSee Starter Rope Replacementf13l6Instail starter pawl Q), friction spring, and friction spring links as an assemblyInstall retaining ring CO with sharp side facing out7Check operation of pawlThe pawl should extend when the starter rope is pulled and retract when the rope rewindsInstallation