1994 Johnson/Evinrude "ER" 2 thru 8 outboards Service Manual, Page 234Get this manual
7Place ratchet on pulley8Place cover and friction spring on spindle'111 9Hook end of return spring in slot of friction plateInsert the other end of return spring into hole on pulleyInstall return spring and friction plate together over spindle'111 10Place thrust washer on spindleInstall retaining ring with sharp side facing out11Place rope in notch and turn pulley three turns counterclockwise from its relaxed position r:;:;J 12Feed rope through eyelet on starter housingWhen there is still approximately 12 in(30 cm) of rope outside the starter housing, tie slipknot in the rope to hold in placeInstall motor cover panel onto starter housing r:J3l 13Install handle onto ropeTie knot in end of ropeInsert knotted end of rope into handle