1994 Johnson/Evinrude "ER" 2 thru 8 outboards Service Manual, Page 222Get this manual
r:t7l14Inspect the driveshaft bearing in placeIf necessary, remove the bearing and sleeve using the slide hammer and OMCTwo-Jaw Puller, PIN 391012The jaws ofthe puller must be reversed so the jaw tips are facing inwardUse stiff rubber band to keep the jaws togetherr:j8l15Inspect the pinion bearings in placeIf necessary, remove the bearings using OMC Bearing Remover, PIN 319880Place shop cloth inside the gearcase to catch the bearings and toolIf pinion bearings are removed for any reason, they must be replacedr,gl16Temporarily install the gearcase head into the gearcase with the two screws, finger tightUsing OMC Small Puller Assembly, PIN 432131, remove propeller shaft sealWhen installing the puller on the seals, be sure the jaws catch the seals and not the bushing in the gearcase head 120117Remove the driveshaft seals from the gearcase cover