1994 Johnson/Evinrude "ER" 2 thru 8 outboards Service Manual, Page 215Get this manual
30 22293
r:;;;J 7Place the pinion thrust washer in the gearcase with chamfered side facing top of the gearcasePosition the thrust bearing then the pinion
1291 8Lubricate, 1301 9
install the driveshaftRotate the shaft to engage the pmlon the water intake screen in the gearcase with tabs
facmg up
L!!J new impeller place gasketPosition the gasket and impeller
plate on the gearcaser:;:;J 11Apply OMC Needle Bearing Assembly Grease to the
r;;l 10Apply OMC Gasket Sealing Compound to both sides of a
impeller drive pin
CDPlace the
pin on flat of the driveshaft
1331 12Oil and install new water pump grommet1341 13Lightly coat the exterior of the impeller cup with OMC
Gasket Sealing CompoundPlace the impeller cup in the impeller housingLightly oil the impeller blades and install the impeller in the housing in counterclockwise direction